URBANE™ NAILSTRIP

We are Sydney's UrbanE™ Standing Seam Supply Specialist with
the best service, experience, and extensive product range.

URBANE™ NAILSTRIP

No 1 Roofing & Building Supplies are the premier manufacturer and stockist of UrbanE™ Nail Strip Roofing and Cladding products,

URBANE™ NAILSTRIP ROOFING & CLADDING

The UrbanE™ Nail Strip panel has a thin rib and wide tray with a perforated fixing strip along one side. There is no need for fixing clips or the additional operation of seaming.

This ensures speed and ease of installing panels whilst allowing for expansion and contraction. It can be used for vertical facade or roofing applications.

Available in 25mm and 38mm rib height, the Nail Strip comes in various widths and lengths to suit your project

These architectural cladding panels are connected by an interlocking groove giving it an elegant appearance of a recessed joint. The reveal panel can range from 200mm to 300mm in width and lengths up to 6.0 m

Nail Strip Specification Detail

Supports needs to be ventilated, rigid and continuous where all parts of the UrbanE™ Nail Strip panels are laid EXCEPT for 38mm x 265mm Colorbond/Zincalume/Metallic/Ultra which can be installed on a 40mm batten at maximum 600mm centres.

The plywood minimum thickness shall be 15mm. UrbanE™ Nail Strip panels are laid and fixed directly to the plywood substrate along the perforated strip every 300mm with concealed screws or nails.

The high rib is then placed over the low rib and snapped into place along the length of the panel.

Material choice to be verified by client and installation must be in accordance with the BCA.

MATERIAL AVAILABILITY

  • Colorbond

    0.55mm BMT Colorbond / Zincalume / Metallic / Ultra
  • Copper

    0.7mm BMT Copper
  • Aluminium

    0.7mm BMT Aluminium
  • Zinc

    0.7mm Zintek Zinc, VMZinc, RheinZink, Jarden Zinc

URBANE™ NAILSTRIP CHARACTERISTICS

Standard Module Sizes 25 X 295mm 25 X 495mm 38 X 265mm 38 X 465mm
Rib Height 25mm 25mm 38mm 38mm
Lengths (Min - Max) 1m - 6m (4m recommended)
Application New construction or renovation
Minimum Pitch Requirement 7.5 Degrees (3 Degrees with lap silicone seal)
  • Custom widths available upon request.
  • Dimensions are subject to -/+ 10mm tolerance.
TOP